Section-2: Operating Machine; Control Panel - Spinshot Player User Manual

Section-2: Operating Machine

Control Panel

POWER: The switch is used to turn on or off
the machine. After you turn on the power, both
horizontal and vertical motors will perform a
functional initialization for proper functioning of
the device. After initialization, the machine will
keep beeping. Then the user needs to re-
position the machine perpendicular to the
baseline facing the opposite side of the
court (see Q3 in section-7 for more details).
Proper placement will make the machine sweep
the balls evenly across the court. Then the
user can press the START button to trigger the
machine to serve the balls. Each time after
powering up, the machine will recall the last
settings for drill mode and start its operations.
If at any time the machine functions incorrectly,
the user can turn off the power button to reset
the device's control logic. Low battery voltage causes most of the
time, the improper working of the machine.
RESET: The white reset switch protects the electronics and motors.
When activated, this switch pops out approximately 6 mm. In the
event the reset is activated, turn off the central power, press the
reset switch, check any balls jammed inside machine and then turn
on the main power to normal operation status. The "reset" can be
caused by excessively dirty or slick ball throwing wheels, which can
prevent the wheels from properly grabbing the balls. Cleaning the ball
throwing wheels as described in the section "Maintenance and
Cleaning" will restore proper performance.
:
CHARGER Plug the charger into the jack and the other end into a
power outlet to start the charging of your machine.
START: The button will trigger the machine to start.