Table of Contents
Advertisement
LAMP indicator
Indicator
Illuminated (red)
Flashing (red)
display
It is nearly time to
An abnormality has been detected in the lamp
Problem replace the lamp
circuit.
unit.
• Does "REPLACE
• The power may
• There may be an
LAMP"
appear on
have been turned
abnormality in the
Possible
the screen after
on straight away
lamp circuit.
cause
the projector is
after it was turned
• The lamp unit may
turned on?
off.
be blown.
• This occurs when
• Wait for a while
• Disconnect the
the operation time
until the lamp unit
power cord by
for the lamp unit is
cools down before
following the
nearing 1 800
turning the power
procedure on
hours (when
back on again.
page 28
,
and then
"LAMP
POWER"
contact an
has been set to
Authorized
Remedy
"STANDARD" and
Service Center.
when "AI" has
• Ask your dealer or
been set to
an Authorized
"OFF"). Ask your
Service Center to
dealer or an
replace the lamp
Authorized
unit. (page 60)
Service Center to
replace the lamp
unit. (page 60)
NOTE:
• Be sure to disconnect the power cord by following the procedure given
in "Turning off the power" on page 28 before carrying out any of the
procedures in the "Remedy" column .
• If the TEMP indicator is illuminated and the power turns off after the
procedures in the "Remedy" column have been carried
out,
it means an
abnormality has occurred. Please contact an Authorized Service Center
so that the necessary repairs can be made.
58-ENGLISH
Advertisement
Table of Contents
