Sony dsc-g1 Service Manual page 6

Self-diagnosis Code
Block Detailed
Function Code
E 6 1 0 0
E 6 1 1 0
E 6 2 0 2
E 6 2 1 0
E 6 2 1 1
E 6 2 1 2
E 6 2 2 0
E 9 1 0 1
DSC-G1_L2
Message Symptom/State
Detected the focus initialize
-
error.
Detected the zoom initialize
-
error.
Abnormality of IC for
-
steadyshot.
Abnormality of IC for
- steadyshot.
(Lens initializing failure)
- Lens overheating (PITCH).
- Lens overheating (YAW).
- Abnormality of thermistor.
(The flash icon Abnormality when flash is
blinks at 3.2 Hz) being charged.
Retry turn the power on by the power switch.
If it does not recover, check the focus sensor
signal (pin ea of CN301 on the SY-153 board)
and check the focus drive signal (pin qk to wa of
CN301 on the SY-153 board) of lens block.
If the focus drive signal is abnormality, check or
replace the zoom/focus motor drive IC (IC301 on
the SY-153 board). If the focus sensor signal is
abnormality, replace the lens block.
Retry turn the power on by the power switch.
If it does not recover, check the zoom sensor
signal (pin wk of CN301 on the SY-153 board)
and check the zoom drive signal (pin ws to wg of
CN301 on the SY-153 board) of lens block.
If the zoom drive signal is abnormality, check or
replace the zoom/focus motor drive IC (IC301 on
the SY-153 board). If the zoom sensor signal is
abnormality, replace the lens block.
Check or replace the IC for steadyshot (IC603 on
the SY-153 board).
Perform checking of the item E: 62: 11 and E: 62:
12, then check or replace the IC for steadyshot
(IC603 on the SY-153 board).
Check the HALL element signal (PITCH)(pin 1,
2 of CN301 on the SY-153 board) and drive
signal (PITCH) (pin 9 to qs of CN301 on the
SY-153 board) of optical image stabilizer, or
replace the lens block.
If they are OK, check PITCH angular velocity
sensor (SE601 on the SY-153 board) peripheral
circuits.
Check the HALL element signal (YAW)(pin 6,
7 of CN301 on the SY-153 board) and drive
signal (YAW) (pin qd, qj of CN301 on the SY-
153 board) of optical image stabilizer, or replace
the lens block.
If they are OK, check YAW angular velocity
sensor (SE602 on the SY-153 board) peripheral
circuits.
Check the OIS temp sensor of optical image
stabilizer (pin 5 of CN301 on the SY-153
board).
Check or replace the flash unit.
1-2
ENGLISH JAPANESE
ENGLISH JAPANESE
Correction