Philips HP L1530R Service Manual page 25

Fig.39
Fig.41
Fig.43
Step 5: Modify DDC data (Monitor Serial No.)
Monitor serial No. can be filled up or be changed as shown in Fig. 44
Click Finish to exit the Step window
DDC Instructions
Step 6: Write DDC data
1. Click
2. Click
The 128bytes DDC data which had been written into DDC IC of
Digital Mode.
Step 7: Save DDC data
Sometimes, you may need to save DDC data as a text file for using
Fig.40
in other IC chip. To save DDC data, follow the steps below:
1. Click
and give a file name as shown in Fig. 45.
2. Click . Save
Fig.42
Step 8: Load DDC data
1. Click
2. Select the file you want to open as shown in Fig 46.
3. Click Open
Fig.44
Step 9: Exit DDC program
Pull down the File menu and select Exit
NOTE: If the
Win 95/98with some problem, try to run it in win 2000,
but you should install the
The other step is the same as describe
HP L2025 HP L1530
Go to cover page
(Write EDID) icon from the tool bar to write DDC data.
(Read EDID) to re-confirm (check contents) it.
(Save) icon (or click "file"-> "save as") from the tool bar
Hp1530-ddc-digital
R
from the tool bar.
R
Hp1530-ddc-digital
edid46Release For writing block 4
EDID_PORT_TOOL
25
7
25
HP L2025 HP L2025
run in
first.
above .