Pentax AF-360FGZ Operating Manual page 28

00_AF360FGZ.book Page 26 Tuesday, June 13, 2006 12:09 PM
Procedure
1
Turn on the power switch.
2
Press the flash mode button (MODE) until (A) is
displayed on the LCD panel.
3
Set the aperture value and ISO.
 Press the select button (S) so that (f/stop) on
the LCD panel blinks.
 Turn the adjustment dial to set the aperture
value.
l The effective flash range is displayed on the LCD
panel bar graph.
 Confirm that the subject is within the effective
flash range and press the select button (S).
 Turn the adjustment dial to set the ISO after
(ISO) starts blinking.
 Press the select button (S). The setting is
complete if (ISO) stops blinking.
4
Set the lens aperture to the same aperture value
as that set on the LCD panel.
l The camera's aperture value is synchronized
with that of the flash unit when the camera
exposure mode is set to Programmed AE or
Shutter Priority AE.
26
5
Set the zoom position. (The setting method
differs according to your camera and lens. Refer
to page 18.)
l Select (M.Zoom) regardless of the type of lens
being used.
6
Confirm that the subject is within the effective
flash range and the ready lamp is lit. Then take a
picture.
l In the following cameras, if the correct flash
output is obtained, the flash mode indicator and
( ) in the viewfinder will blink.
645, LX, Super A/Super Program, MZ-M/ZX-M,
P30T, P30N/P3N, P30/P3, P50/P5, A3Date,
A3DateS, Program A/Program Plus
For details, refer to "Auto Check Display" on
page 9.
l If the power is turned temporarily OFF, the flash
will be set to P-TTL or TTL auto. Return the
setting to Auto flash.
l The sync mode will be fixed in leading curtain
sync.