Using The Remote Control Unit (Optional) - Pentax Optio S55 Operating Manual

Using the Remote Control Unit (optional)

You can switch the Drive mode to Remote Control mode and take
4
pictures using the remote control unit for Pentax cameras (optional).
The remote control receiver is on the front of the camera. Operate the
remote control unit toward the camera lens.
1
Press the four-way controller (2)
in Capture mode to displayh on
the LCD monitor.
The self-timer lamp blinks slowly and the
camera is ready to take the picture.
2
Press the zoom button to adjust the
zoom (for remote control unit E).
The zoom position changes each time the zoom button is pressed in
the following sequence: tele
3
Press the shutter release button on the remote control
unit.
hThe picture is taken immediately.
iThe self-timer lamp blinks rapidly and the picture is taken after
approximately three seconds.
• Focusing position may shift if you move the camera while the self-timer
lamp is blinking.
• When the Focus mode is set to Super Macro mode, the zoom
magnification does not change.
• The buttons on the camera can be used in the normal way.
• Ensure that the remote control unit is no more than four meters away
from the front of the camera.
60
1
Remote control unit E
(Remote control unit F has no zoom button.)
- d R + C . H =
middle wide
3
2
4 4
0 6 / 1 0 / 2 0 0 5 0 6 / 1 0 / 2 0 0 5 0 6 / 1 0 / 2 0 0 5
1 0 : 2 5 1 0 : 2 5 1 0 : 2 5