Lancom 800+ Installation Manual page 27

LANCOM Routers, WLAN Routers, Access Points and WLAN Controllers


Further information and support
Should you have any queries, or should you require any further support regar-
ding the topics discussed in this documentation, the following sources of
information are available to you:
11
Reset-or-boot (standard setting): Press the button briefly to restart
the device. Pressing the button for 5 seconds or longer restarts the
device and resets the configuration to its factory settings. All LEDs on
the device light up continuously. Once the switch is released the
device will restart with the restored factory settings.
After applying the reset, the device will start fresh with factory
defaults. All settings will be lost. Therefore, you should save the cur-
rent configuration if possible before the reset!
Please notice that also the WLAN encryption settings of the device will
get lost in case of a reset. The wireless configuration of a LANCOM
WLAN Router will only succeed after a reset, if the standard WEP key
is programmed into the WLAN adapter! After a reset, the LANCOM
access point returns to managed mode, in which case the configura-
tion cannot be directly accessed via the WLAN interface!
In the service- & support section
answers on „Frequently Asked Questions ('FAQs')" can be found, the LAN-
COM knowledge data base („Support KnowledgeBase" with whole text
search), as well as telephone numbers and contact addresses.
In the download section
firmware, tools and documentation are available at any time.
First steps
on www.lancom.eu/support
on www.lancom.eu/download
many
current drivers,