Lancom 800+ Installation Manual page 23

LANCOM Routers, WLAN Routers, Access Points and WLAN Controllers

... via serial interface

... via dial-up networking/ISDN connection (remote
configuration)
7
server, then the device can be accessed by the name "LANCOM <MAC
address>" (e.g. "LANCOM-00a057xxxxxx").
http://LANCOM-00a05700094A
The MAC address can be found on a label at the bottom of the device.
If there is no DNS server in the LAN, or it is not linked to the DHCP server,
then the device can not be reached by the name. The following options
remain in this case:
Figure out the DHCP-assigned IP address of the LANCOM by suitable
tools and contact the device directly with this IP address.
Use LANconfig.
Connect a PC with a terminal program via the serial configuration
interface to the device.Connect a PC with a terminal program via the
serial configuration interface to the device.
If no LAN access can be established to the device,
serial configuration interface
LANconfig or a terminal
For outband configuration via terminal program it is not possible to
use setup wizards. The use of LANconfig is again the most convenient
configuration method.
If your device is reachable at a remote location via ISDN, you can confi-
gurate it remotely with LANconfig. Further information about
configuration can be found in the reference manual.
First steps
and carry out the configuration via
program.
connect the PC via the
remote