Wiring Connections; Main 5 Pin Harness - Omega REC-12 Operation And Installation Manual

..
'~~'"
Wiring Connections
MAIN 5 PIN HARNESS
BLACK: (-) Chassis Ground- This wire supplies ground for all of the system's
operations. Connect this wire to the metal structure of the vehicle preferably
using an existing machine screw or bolt. Cut the wire to the shortest practical
length and crimp on a proper sized ring terminal. Be sure the metal surface
bright and clean of paint, dirt, or grease.
RED: (+) 12 Volt Constant Power- Connect this to a constant +12 volt supply
in the vehicle like the ignition switch's supply circuit or the vehicle's battery.
YELLOW: (+) Ignition Power- Connect this to the primary ignition circuit. It will
show +12 volts when the ignition is in the ON/RUN
&
START positions only.
GRAY: (-) Trunk Release/2nd Channel Output- This wire has a 1 second
250mA negative output whenever trunk release is activated by the transmitter.
In some cases, a relay is required to "step up" the output to have higher current
or positive polarity. This is vehicle dependent.
ORANGE: (-) Starter Disable Output- This wire provides a constant 500mA
negative output whenever the system is LOCKED by the transmitter or when
anti-carjacking mode is activated. Connect it to the included starter disable re-
lay socket. SOCKET CONNECTION: Cut the vehicle's starter wire, connect the
socket's RED wire to the side of the wire that still shows +12V when the key is
in the start position, then connect the WHITE wire to the starter side of the wire.