Introduction; Features; Installation - Polaroid PBC-A56J User Manual

INTRODUCTION

The Back-Up Camera displays images behind the vehicle, and is used when backing up a
vehicle.When the vehicle is driven in reverse, the camera is activated, which sends a signal to
the Transmitter. The transmitter sends a video signal to the monitor, which then displays the
view captures by the camera.

FEATURES

Color monitor displays view from the rear of the vehicle. Wireless monitor can be suction-
mounted to windshield or dash for easy visibility Adjustable monitor bracket. Adjustable
vertical camera. angle Weatherproof camera with 120 degrees viewing angle. Reduce the
danger of harm or damage due to unseen objects. System activates automatically when car is
shifted into reverse.
6
7
1
Legend
1.Wireless Camera (Built-in Transmitter)
4.Wireless Monitor
7.Monitor Cigarette Lighter/Accessory Socket Power Cord
4
3
2
5
2.Ties
3.bracket
5.clip 6.USB Socket
-3-

INSTALLATION

NOTICE
Some states or local governments may have regulations or laws that restrict the use of
anything that might impair the clear view of a license plate. Check local laws for compliance.
NOTICE
For the Back-Up Camera to be properly installed, it must be wired into the vehicle's taillight
harness. If you are not comfortable or knowledgeable with 12-volt DC wiring, have the system
professionally installed.
NOTICE
These instructions are only meant as a general guide due to the number of different makes and
models of vehicles. For vehicle-specific questions, contact your vehicle's manufacturer.
4. Adjust the camera as required:
.
To adjust the camera angle, tilt the camera to one of the five positions.
.
The camera should be adjusted to a horizontal position relative to the ground so as to provide
optimal view of objects behind the vehicle.
.
To adjust the camera height, remove the camera adjusting screws, move the camera to line up
with the desired holes and install the camera adjusting screws. Make sure the arrows on the
back of the camera are pointing upward.
1.Remove the screws that hold the license plate
to the vehicle.
2.Position the camera mounting plate behind the
license plate.
3. insert the screws through the license plate, the
camera mounting plate and the
washers. If your hardware is not the correct
length, use the supplied hardware.
-4-