Compact Disc Operation - Hyundai H-1416 Instruction Manual

Portable stereo radio cassette recorder with cd/mp3/usb/sd/mmc
Hide thumbs Also See for H-1416:
Table of Contents

Advertisement

Available languages

Available languages

Erase protection
• To prevent accidental erasing of a cassette, simply break off the two plastic tabs located on the cassette tape's rear side.
• When a cassette with removed plastic tabs is inserted, the recording button cannot be pressed.
• If a cassette is to be erased and re-recorded at a later stage, simply cover the holes on the cassette where the tabs were removed,
with a piece of strong adhesive tape.
Insertion & removal of discs
• When opening the CD-door, always ensure the disc is not in motion (not spinning) when you open the CD-door. Always press "STOP" button to stop the
disc spinning first.
• Place a CD into the compartment with the label-side (printed side of disc) facing upwards. Press down in the center part of disc until the disc "locks" onto
the center spindle.
• When the CD has been placed onto the center spindle, gently lower the CD-door downwards until it locks shut.
• The CD is now ready to be played.
• To remove a disc, follow the same procedure as described above, except to remove the CD instead of inserting it into the compartment, by placing one
finger at the middle of disc (center spindle) & the other at the edge of the disc & gently pulling upwards.
Important :
Always hold a CD by its edges. Avoid getting any finger prints, smudges or dirt onto the surface of a disc. In case this happens, use a special CD-cleaning
cloth or cleaning kit to remove the dirt or smudges.
Important:
Please make sure to always fold down the handle before opening the CD door.

Compact disc operation

• Set FUNCTION switch to CD (MP3) position.
• Put a CD into the CD compartment and close the CD door.
• The LCD display will show the total number of tracks after a few second.
Play/pause mode
• Press the CD PLAY/PAUSE button to start play, the LCD display will show the first track.
• Press the CD PLAY/PAUSE button to pause at any track when playing, track number on the LCD display flashes.
• To stop the CD, press the CD STOP button.
Skip and search mode
• Press the NEXT/TUNE UP button once to skip to the next track. Press and hold this button to search for a particular point at high speed forward. Release
the button to resume normal play.
7

Advertisement

Table of Contents
loading

Table of Contents