Hyundai H-1416 Instruction Manual page 8

• Press the BACK/TUNE DOWN button once to skip back to previous track. Press and hold this button to search for a particular point at high speed
backward. Release the button resume normal play.
Repeat mode
• Press the CD MEMORY/REPEAT/PROG button once for single track repeat playing.
• Press twice for all track repeat playing.
• To cancel repeat play, press MEMORY/REPEAT/PROG button again.
Program mode
• Up to 60 tracks can be programmed for disc play in any order or the same track can be repeated up to 60 times.
• Before use, be sure to stop the CD by pressing the CD STOP/ CD/USB/SD/ FM MODE button.
• Press the MEMORY/REPEAT/PROG button. The display will show "P01" and "PROG" symbol.. This indicates that the set is now in memory
programming mode, at the first memory position.
• Select a desired track by using the BACK/TUNE DOWN and NEXT/TUNE UP buttons.
• Press the MEMORY/REPEAT/PROG button again to confirm.
• The set will advance to next memory position, the display will show "P02".
• Repeat steps described above to enter additional memories into the program if necessary.
• After a maximum of 60 songs (or less) have been selected as described above, press the CD PLAY/ PAUSE button to start playing the programmed
tracks.
• The "PROG" symbol will remain to indicate that you have saved a program-memory (sequence).
• The program memory will be cleared when you press CD STOP button or turn off the CD or power supply.
MP3 operation
• Set FUNCTION switch to CD (MP3) position.
• Open the CD door. Put a MP3 disk into the CD compartment and close the CD door.
• The disk will spin and perform a full check of the disc to count the total number of songs. Then playback of the first song (track) will begin and the
display will indicate the current track no: (001).
• If your disc has folders, the display will show the folder number (eg. F01, F02, etc...) every 5 seconds.
• At any time during playback, press and release BACK/TUNE DOWN orвы NEXT/TUNE UP buttons to skip backwards or forwards by one track.
• If your MP3-CD has no folders, you can use the "skip +10/folder" button to jump 10 songs ahead. This is useful if you have many songs on you want to
quickly jump to a particular song.
• Press "skip +10/folder" several times until you reach a song number near to your desired song, and then press "back" or "next" repeatedly to arrive and
the exact song you desire.
(note: the "skip +10" function only works on MP3-discs which have no folders).
• If your MP3-CD has folders, you can select the folder to playback. Press and hold "skip +10/folder" button until the "folder" symbol flashes.
• Within 5 seconds press BACK/TUNE DOWN or NEXT/TUNE UP button to select the desired folder.
8