Operation - BD -125WP Owner's Manual And Operating Instructions

BD-125WP
Polishing Operation
NOTE: Smoothing of the surface during the use of the coarse polishing discs will deter-
mine the quality of the finish that is achieved.
(A)
Place the ON/OFF Switch
in the ON position.
(D)
After working the area, shut
the water supply off.
NOTE: Once all of the large scratches and marks have been removed, use the finer grit
polishing discs (400, 800, 1800 and 3500) for a quality finish. For a higher luster/
color, finished surface, use the extremely fine 8500 grit polishing disc.
(G)
Repeat Steps A through F
until all large scratches have
been removed.
(B)
Adjust water flow
(excessive water flow can result
in internal electrical problems).
(E)
Place the ON/OFF Switch
in the OFF position.
(H)
Change to fine grit discs for
a quality finish.
17

OPERATION

(C)
Using the coarse grit disc, re-
move all rough scratches
and cut marks.
(F)
Dry surface then rub the surface
with a lumber crayon to deter-
mine the depth of the remaining
scratches.
(I)
Repeat Steps A through F using
fine grit discs to complete polish-
ing of the surface.