Getting And Sending Of The Platform - Lippe Lift Konstanz Operating Instructions Manual

4.5 Retrieving and sending of the platform (standard design)
Make certain before every trip that the acoustical and if present, the visual (optional)
warning signals are functioning. The platform lift Konstanz can be retrieved from
every stopping point or sent to another stopping point. For this, the key switch at the
corresponding stopping point should be inserted and turned in the corresponding
direction and held firmly in this position.
The platform lift does not respond immediately, but rather after a delay of around 2
seconds.
Comment: The lift travels from the external control points only when folded
Note: An LED is attached to the transmitter for the retrieving and sending of the
chair lift.
GREEN:
ORANGE: Battery power is decreasing, replace batteries
RED: Battery power is very weak, replace batteries
immediately
Retrieving and sending of the platform lift (Special design 1) [using the external
control device, only with key switch with 3 settings (S.7.8 item 2) for travel with
opened platform via the external control device]. This option must be activated by a
technical specialist within the control system. It must be ensured that no third person
can land/spring onto the travel route. Condition: Travel area is 100% visible !!!!
The key switch (S.7.8 item 2) must be set to position –II- otherwise as in 4.5.
Retrieving and sending of the platform lift (Special design 2) [using the internal
control, only for key switch with 3 settings (S.7.8 item 2)]. This option must be
activated within the control system by a technical specialist.
Using the internal controls, the platform can be driven into the folded-down
position. For this, the key switch ( (S.7.8 item 2) must be set to position II. Now the
platform lift can be driven using the internal controls (S.7.8 item 1).
In the case of more than two stopping points: The platform lift will stop
automatically at each intermediate stopping point and possible fold out, in the case
of an automatic platform. If this is not desired, then a new travel command should be
given and the platform lift drives on.
Operator manual Konstanz STG/ASA
together, i.e. the floor of the platform must be folded up and the safety
gates must be folded down.
Batteries are in order
when convenient
12/20 Version 8.0 (01/2010)