Advertisement
ADJUSTING THE THROTTLE LEVER TO ANGLE HEAD LOCATION
1. REMOVE THE ANGLE HEAD
1.1. Hold the angle head and with a 1-3/8" crows foot loosen and remove the gear casing
from the angle head.
2. INSTALL ADJUSTMENT SHIMS
2.1. Shim kit part number 25444 is needed for the 1000 series.
2.2. Add adjustment shims as needed to align the angle head with the throttle lever.
3. REINSTALL THE ANGLE HEAD
3.1. Apply Loctite 243 to the threads on the angle head.
3.2. Hold the angle head and tighten the gear casing to 40NM using the 1-3/8" crows foot.
APPLY LOCTITE 243 (BLUE) PRIOR
TO INSTALLATION INTO ITEM # 7
TIGHTEN TO 40 Nm (29.5 FT-LBS)
8
(REQUIRES OPTIONAL P/N 25444)
B
7
34.9MM (1-3/8") FLATS
40Nm (30 FT-LBS.)
9
10
11
SHIM AS REQUIRED
WITH ITEMS 9-11 TO
ALIGN ANGLE HEAD
TO LEVER
8
PRESS INTO ITEM 2
UNTIL FLUSH WITH
SURFACE
6
2
SEE NOTE # 1
4
3
Advertisement
