ZyXEL Communications AMG1202-T10B Support Notes page 52

AMG1202-T10B/AMG1302-T10B
Support Notes
 Enter the IP address of the PPTP server (WinNT server) and the
port number for PPTP as shown below:
Select service name as 'PPTP', fill in the Server IP Address, then press button
'Add'.
When you have finished the above settings, you can ping to the remote Win9x
client from WinNT. This ping command is used to demonstrate that remote
the Win9x can be reached across the Internet. If the Internet connection
between two LANs is achievable, you can place a VPN call from the remote
Win9x client.
For example: C:\ping 203.66.113.2
When a dial-up connection to ISP is established, a default gateway is assigned
to the router traffic through that connection. Therefore, the output below shows
the default gateway of the Win9x client after the dial-up connection has been
established.
Before making a VPN connection from the Win9x client to the NT server, you
need to know the exact Internet IP address that the ISP assigns to
AMG1302-T10B/AMG1202-T10B router in SUA mode and enter this IP
address in the VPN dial-up dialog box. You can check this Internet IP address
from PNC Monitor or S Web Configurator, Status -> WAN Information. If the
Internet IP address is a fixed IP address provided by ISP in SUA mode, then
you can always use this IP address for reaching the VPN server.
In the following example, the IP address '140.113.1.225' is dynamically
assigned by ISP. You must enter this IP address in the 'VPN Server' dialog box
for reaching the PPTP server. After the VPN link is established, you can start
the network protocol application such as IP, IPX and NetBEUI.
52
All contents copyright © 2013 ZyXEL Communications Corporation.