Configuring The Video Camera(S) For The First Time - Pentair ScreenLogic BB-HCM311A User And Installation Manual

6
3. The software will configure the smaller
ScreenLogic Protocol Adapter for use with
the Video & Lighting Protocol Adapter. A
"System Configuration Complete"
message box will be displayed. Click OK
to continue with the installation. Please be
patient while the Video & Lighting Protocol
adapter synchronizes the settings from the
IntelliTouch system for the first time. This
can take anywhere from 3 to 15 minutes
depending upon the complexity of your
IntelliTouch system.
Note: When synchronizing is complete, the
current system information is displayed in
the dialog box (see dialog on right).

Configuring the Video Camera(s) for the First Time

To configure the video camera(s) for the first
time:
1. Connect the RJ45 camera cable to the
ScreenLogic Wireless Router port 1, 2, 3,
or 4 and plug in the camera. See page 2
for connection diagram. Please allow the
video camera 45 seconds to power up
before proceeding.
2. Click the Configure Video button to
configure the camera.
3. Click the Add New Camera button.
4. Click the OK button on the message
dialog box. Ensure that the camera was
plugged in within the last 20 minutes.
ScreenLogic Video & Lighting Protocol Adapter User's and Installation Guide