Table of Contents
Advertisement
Do not stack anything on top of your VCR, or block
the air vents, to prevent damaging
or overheating.
Do not place anything, except VHS video cassette
tapes, in the unit.
Do not allow rain, steam, dew, salt water, sand, oily
smoke, metal objects, etc. entering the unit.
The
POWER
button of this VCR is a secondary
"Stand-by"
is the condition
in which only the time is
circuit, and does not disconnect
the unit from
displayed.
the wall outlet, even if the VCR is in stand-by, as
long as the power cord is connected
to the VCR
power socket.
Caution concerning condensation
Be careful of condensation
Condensation
is the moisture that forms on the
outside of a glass when you fill it with cold water,
Condensation
can also form inside a VCR when it is
suddenly moved from a cold place to a warm, humid
one, or when a heater has been turned on to quickly
heat the room.
Particular care must be taken with your VCR because
water particles that form on the video head drum,
which is the main VCR mechanism,
can cause the
video tape to stick to the drum, This prevents proper
tape travel and may damage both tape and
mechanism,
Follow the procedures
below the first time you
use the VCR, and whenever you use it in places
which are subject to condensation:
6
;
OConnect
the aerial output cable and make all
other necessary connections.
@
Plug
the
power
cord into a wall outlet,
@Turn
on the VCR power to warm it up and
speed up the drying of any water particles
that may have formed on the video head
drum,
@Do not insert a video cassette,
Wait for 1-1/2 to 2 hours before using the
VCR.
=S$$S$s
—T#r,w/,-,$m*w.>wf
Msg92
INTRODUCTION
4
Advertisement
Table of Contents
