Table of Contents
Advertisement
New Zealand only
Tuning or presetting the VCR channels
For New Zealand conditions,
presetting
channel
using auto tuning is not advised. This is due to the
order that television stations will be preset in some
New Zealand cities.
Use the manual tuning mode (refer to "Manual
tuning"),
This will ensure the channels are preset in the
correct positions and you will have full control of
tuning.
This is very important for correct G-Code operation,
Ideally for simpler operation, channels should be
preset as follows:
Television
station
Programme
position
number
TV One
1
TV TWO
2
TV Three
3
For additional
channels in your area it is over to
you to select the most logical channel position to
place them,
* Sky Television
4
* Canterbury TV
5
* Action TV
6
* When you use the G-Code function to
programme
a recording from a certain channel for
the first time, it will ask you the programme
position
number that channel was preset to, That setting will
be memorized and automatically
set the next time
the same channel is selected.
Auto tuning
I
The channels available in your area will be
automatically
preset in order, starting from
programme
position number"1".
Notes:
Auto tuning is not possible if the VCR is set to AV
input mode,
For manual tuning, go directly to step @ under
"Manual tuning",
~
Using the
cursor (7) button,
select
"AUTO".
@
Press the
OK
button.
The ATM (Auto Tuning Memory) function will
start and proceed in order from programme
position number"1".
When all available
channels have been preset, the function will
stop and the channel preset to programme
position number"1"
will
be tuned on your TV
screen.
The skip function will be set for all position
numbers where no channel has been preset (see
page 13),
Manual tuning
This tuning mode can be used to modify the settings
entered by the
"Auto tuning",
or to manually preset
the channels to particular programme
position
numbers,
O Press the
MENU~
button,
Main menu is displayed.
@ Using the cursor (~) button, select
"MODE",
then
press the
OK
button,
@With
"TUNING"
selected, press the
OK
button.
Then with
"MANUAL"
selected, press the
OK
button.
MANUAL TUNING menu is displayed,
+
11111111. . . . . . . . . . . . . . . . . . . .
PRG POS.
--
ExamP/e:
To preset TV One to programme
position
"01".
OWith
"CHANNEL"
selected, press the cursor (<
or
) button until the broadcast
from the desired
channel (eg. TV One) appears on the TV screen.
(p): The channel with the next higher frequency
is
searched and tuned.
(<): The channel with the next lower frequency
is
searched and tuned.
Note:
If the search stops on a bad TV screen and the
on-screen display does not appear, press the cursor
(<or
)
button again.
The search will continue,
Fine tuning
When the desired channel appears on the TV screen,
if the tuning is not optimum, it can be improved by
manual fine tuning,
Press the (+ or -) button to obtain the best possible
picture and sound,
To be continued *
2
PREPARATION
12
Advertisement
Table of Contents
