Power Supply; Setting The Clock; Battery Operation - Telefunken TF-1566U Instruction Manual

Instruction manual

Power supply

Battery operation

• Open the battery compartment
cover. Insert 4 x AAA batteries (not
included). Please observe correct
battery polarities or the unit will not
work. Close the battery compartment
cover.
• When the batteries are exhausted,
they should be replaced.
• Do not use new and old batteries
together. Do not recharge or heat the
batteries. Uncharged batteries are not
a reason for addressing to a repair
service.
• Disconnect power cord from the
socket, when the unit is on battery
supply. Battery power is automatically
disconnected when the power cord is
connected to a power socket.
AC adaptor power
• Plug the supplied AC/DC power
adaptor into the power input on the back
of the unit. Connect the power cord to
the AC household main outlet. Make
sure the voltage is compatible.
• Always remember to disconnect
the power cord from the main supply
before disconnecting it from the unit.
• Disconnect the power cord from
the mains when not in use.
Additional power
• Insert 2 batteries AG13 into the
additional battery terminal. This is
4
4
additional power supply intended
for maintenance of clock and alarm
settings. Without the additional power
you will need to set the clock and alarm
anew after each interruption of power
supply.
• When the batteries are exhausted
they should be replaced. New batteries
should be aquired by user. Replace
the batteries only with batteries of the
same type.

Setting the clock

Set the function switch to MODE
position. Press and hold CLOCK
button on the RC (TIME SET/MEM-
UP/12H/24H button on the unit) until
the digits flash. Press repeatedly
/TUN- and /TUN+ buttons on the
unit ( /TUNING and
buttons on the RC) to set 12-hour or
24-hour clock display mode. Press
CLOCK (TIME SET/MEM-UP/12H/24H)
button to go to hour setting, hour
digits will flash. Press repeatedly
/TUN- and /TUN+ (
and /TUNING) buttons to set hours.
Press CLOCK (TIME SET/MEM-
UP/12H/24H) button to go to minute
setting, minute digits will flash. Press
repeatedly /TUN- and
/TUNING and
to set minutes. Press CLOCK (TIME
SET/MEM-UP/12H/24H) button to
confirm clock setting.
/TUNING
/TUNING
/TUN+ (
/TUNING) buttons