Table of Contents
Advertisement
Available languages
Available languages
Instruction manual
Important safeguards
• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer to the
manual. Keep the manual for future use.
• Do not hit or drop the unit
• Do not expose the unit to vibration, direct
sunlight, too high or low temperatures or
humidity.
• Do not disassemble the unit yourselves
Refer servicing to qualified service personnel
All the illustrations in this manual are
schematic images, which may differ from
actual objects.
Power supply
• The unit operates on an internal
rechargeable Li-ion battery.
• The battery can be recharged with the
provided USB charging cable. Before first
plugging the appliance check that voltage
indicated on the rating label corresponds
to the mains voltage in your home.
• Insert the charging cable into the
DC 5V socket at the top panel of the unit.
• Connect the charging cable to the power
source. The unit is charging when the red
LED indicator is on.
• For best results, try to fully charge the
battery before each use. If the battery is
drained, please allow it to recharge for a few
hours.
• Put the OFF/ON switch into ON
position to switch the unit on. Put it into OFF
position to switch off.
General operation
Backlight brightness
• Press the DIMMER button to select
between the levels of display backlight
brightness.
3
Setting the clock
• Press the
button.
The time will start to flash.
• Press the - and + buttons
to set the HOUR. Press the
hour is set.
• Press the - and + buttons
to set the MINUTES. Press the
the minute is set.
• Choose the 12- or 24-hour format.
Press the - and + buttons to select,
• The time is now set.
You can press the
button any time to go to
clock display from any operation mode.
Setting the alarm
• Press the
button to go to
Alarm Clock 1 mode.
• Press the
button to
set the alarm hour. Use the - and + buttons to
set and press
to confirm and go to minutes.
• In the same way set the
alarm minutes, signal and circulation.
• You have 7 options when selecting
the alarm signal. The first 5 are built-in ring tones.
Number 6 is the first track from the TF (microSD)
card. Number 7 is the last played FM radio
station. Press + and - to select,
• When selecting circulation you can
set the alarm to go off every single day of the
week or just once. If every day circulation is set,
the special symbol will light on the display.
• When finished, press and hold
to confirm the settings and activate the alarm.
• Alarm Clock 2 is set the same
way as Alarm Clock 1. Use the
button after the
button after
to confirm.
to confirm.
button instead.
Advertisement
Table of Contents
