How To Use Camera; Hardware Connection - Ventus WT816 Manual

Bottom View
Figure 1.3
Original IPCAM have some stickers at the bottom, such as MAC address sticker, QC sticker etc.
RESET
Press and hold the RESET BUTTON for 10 seconds,then the IPCAM will be reset back to
the factory default Parameter.(Please keep the power on when do RESET)
2 How to Access to IP Camera

2.1 Hardware Connection

Figure: 2.1
Follow the steps below to set up your camera hardware.Make sure to follow each step carefully to ensure that
the camera operates properly
1. Install the Wi-Fi antenna
2. Plug the power adaptor into camera
3. Plug the network cable into camera and router/switch
4. It takes approx 30 seconds to boot up the camera,then you will find the IP address from
"IP Camera Tool" (Figure:2.1)
5. When the power on and network cable connected,the green led of the real panel will keep on,
6. The yellow led will keep flash,and the Indicator led at the front of the camera will flash.(The indicator LED can be controlled by software).
5
WT813 / WT816