Ptz Setting - Ventus WT816 Manual

2. RTSP RELATED SETTINGS
Setup RTSP streaming ports open, setup the port to 10554, then refresh and view to confirm the RTSP state is opened.
4.4 PTZ
Click the "PTZ SETTINGS" appears below interface:
"Indicate light":Setting the LED to the state of turned on or off;
"Ban Preset":The preset function failure when enabled;
"Starts at the preset": 1~16 preset options, aligning the corresponding preset position when startup the device; In forbidden state, the device to
keep the power off before position after startup.
"PTZ Speed": Adjust the PTZ speed;
"Number of Cruises": Set the number of cruises when start up vertical and horizontal, and it will stop at ten minutes once you select "unlimited";
Figure 4.18
Figure 4.19
17
WT813 / WT816