Prevail-Catv WT-1550-DM Operating Manual page 19

WT-1550-DM Intelligent Direct Modulated Optical Transmitter
ethcfg
This command configures the Ethernet parameters, including IP address, subnet mask
and gateway. You can refer to the help information for its using.
settrap
This command shows or modifies the aim host IP address list of the SNMP Trap,
IP address of 0.0.0.0 and 255.255.255.255 don't exist. SNMP Trap does not send to
these two addresses.
community
This command configures the read-only group name and read-write group name.
"Group name" is the concept of SNMP agreement like the password. Use the
command "community ro" to configure the read-only, and "community rw" for the
read-write. For example, input "community rw public", "public" is the read-write
group name. The group name for read-only and read-write are both "public" as the
equipment default setting from factory.
setpswd
This command is used to modify the login password.
entplogo
This command is used to set the logo and equipment model.
Exit
This command is used to log out.
- 18 -