Installing The Wt-1550-Dm Optical Transmitter; Receiving And Inspecting; Precautions; Mounting Wt-1550-Dm - Prevail-Catv WT-1550-DM Operating Manual

4. Installing the WT-1550-DM Optical Transmitter

4.1 Receiving and Inspecting

As you unpack your unit, inspect the shipping container and equipment for damage.
Save the shipping material for future use. If the container or the equipment is
damaged, notify both the freight carrier and us.
CAUTION
To protect yourself from potential injury and to protect
:
the equipment from further damage, do not perform any
operational tests if the equipment appears to be damaged.

4.2 Precautions

Heed the following precautions when working with the WT-1550-DM.
Warning
Warning

4.3 Mounting WT-1550-DM

Mounting
4.3.1 the WT-1550-DM in the
Mounting the WT-1550-DM in the standard 19 inch equipment rack:
1. Place the equipment in the rack.
2. Use four screws fixed the mounting lug on the WT-1550-DM front panel to the
rack.
3. Reliably ground the equipment. The ground terminal is on the rear panel.
4. Visually inspect each key (button) on the front panel to ensure that it is not trapped
under the edge of its hole. If a key is trapped, tap the key to enable it to move freely.

4.3.2 Connecting the RF Cables

Verify the RF input F connector type according to the ordering information, then
screw on the matched RF cable.
WT-1550-DM Intelligent Direct Modulated Optical Transmitter
Read the installation instructions before connecting the
system to the power source.
The plug-socket combination must be accessible at all
times, because it serves as the main disconnecting device.
- 12 -
Rack