Network Connection - Raymarine CAM200IP Installation Instructions Manual

Important: Be aware that the suitable fuse rating
for the thermal breaker or fuse is dependent on the
number of devices you are connecting.
Grounding
Ensure that you observe the separate grounding
advice provided in the product's documentation.
More information
Raymarine recommends that best practice is
observed in all vessel electrical installations, as
detailed in the following standards:
• BMEA Code of Practice for Electrical and
Electronic Installations in Boats
• NMEA 0400 Installation Standard
• ABYC E-11 AC & DC Electrical Systems on Boats
• ABYC A-31 Battery chargers and Inverters
• ABYC TE-4 Lightning Protection
In-line fuse and thermal breaker ratings
The following in-line fuse and thermal breaker ratings
apply to your product:
In-line fuse rating
2 A slow blow
Note:
• The suitable fuse rating for the thermal breaker
is dependent on the number of devices you are
connecting. If in doubt consult an authorized
Raymarine dealer.
• Your product's power cable may have a fitted
in-line fuse, if not then you can add an in-line
fuse to the positive wire of your product's power
connection.
Warning: Grounding not required
This product is fully insulated and does
NOT require separate grounding.
26
Thermal breaker rating
3 A (if only connecting one
device)

4.5 Network connection

The unit must be connected to a compatible MFD or
PC to enable the video feed to be viewed.
PC connection
When connecting the camera directly to a PC
the camera requires a separate power supply
connection. Alternatively a PoE injector could be
used to power the camera.
1
3
Item Description
1 PC
2 IP camera
3 (Optional) RJ45 ethernet cable
4
(Optional) Waterproof RJ45 ethernet
coupler (R32142) (supplied)
5 Camera's ethernet cable
6 Camera's power cable
Note: You can also connect the camera's ethernet
cable directly to the PC's ethernet port, omitting
the additional RJ45 ethernet cable and ethernet
coupler.
For details on available network hardware and
cables refer to Chapter 11 Spares and
Multifunction display connection
The unit can connect directly to a multifunction
display. If the multifunction display provides Power
over Ethernet (PoE) then a separate power supply
may not be required.
3
Item Description
1 MFD rear connector panel
2 IP camera
3 RayNet to SeaTalk
2
6
4 5
12 v dc +
12 v dc -
accessories.
1 2
6
4 5
12 v dc +
12 v dc -
hs (male) adaptor cable
CAM200IP / CAM210IP
D13093-1
D13094-1