Engine Oil; Empty Fuel; Spark Plug - IKRA Mogatec BRM 1751 SSM TL Operating Instruction

4. Loosen the hex bolt anticlockwise using a suitable
wrench and remove it together with the locking flange
and blade (Fig. 26).
Fig. 26
5. Replace the blade with a new one of the same type.
Refit the locking flange and hex bolt. Tighten the hex
bolt clockwise with 50 Nm min, 70 Nm max. to ensure
safe operation of your product.
6. Replace this blade after 100 hours mowing. If the
blade is cracked or damaged, you must immediately
replace it with a new one.
7. Lubricate the blade after each use to prolong the life
span of the blade and product. Apply light machine oil
along the edge of the blade.

4.3 Engine oil

• Check
1. Unscrew and remove the oil tank cap.
2. Wipe the oil dipstick clean; refit and tighten the oil
tank cap and then remove it again. The oil level must
be within the marking and oil should be clear with gold
color.
3. Refill if the oil level is too low.
4. Drain oil if the oil level is too high.
5. Change the engine oil if it is sticky or brown.
• Change
1. Place a suitable container under the oil drain screw
to collect drained oil. Ensure the container has an ef-
ficient volume.
2. Loosen the oil drain screw with a hex key and remove
it (Fig. 27).
GB | Operating Instruction
Fig. 27
oil drain screw
3. Let the engine oil flow into the container.
4. Refit the oil drain screw and wipe of spilled oil.
5. Refill the oil tank as described in section „PREPARA-

4.4 Empty fuel

1. Hold a collection container beneath the fuel tank.
2. Unscrew the tank cap and remove it.
3. Take the machine to bottom up, and drain it.
4. Re do above after several minutes
5. Allow the fuel to run out completely.

4.5 Spark plug

Inspect the spark plug regularly. Clean or replace with a
new one if necessary.
1. Disconnect the spark plug connector.
2. Loosen the spark plug with a spark plug wrench and
3. Check the spark plug for damage and wear. The color
4. Remove debris from the electrode with a soft wired
5. Dry the spark plug with a soft cloth if it is wet from fuel.
6. Check the spark plug gap. It should be 0.7 ± 0.08 mm
Fig. 28
7. Replace with a new spark plug if either the electrode
14
TION - Filling with engine oil".
carefully remove it.
of the electrode should be light-brown colored.
brush; avoid heavy cleaning of the electrode.
(Fig. 28).
0.7 ± 0.08 mm
or the insulation is damaged.