Deck Washing; Change The Blade - IKRA Mogatec BRM 1751 SSM TL Operating Instruction

Part To do
Spark plug check
Spark plug clean
Spark plug replace
Air filter check
Air filter clean
Air filter replace
Fuel filter check
Fuel filter clean
Fuel filter replace
4.1 Deck washing (optional)
When the machine has stopped and is switched off:
- Connect the coupler (X) on the deck to the water-
supply tap.
- Turn on the tap.
- Switch on the engine (the blade should be spinning)
and let it run for a few minutes.
- When the machine is clean, switch off the engine. Turn
off the tap and remove the hose from the coupler.
Fig. 25
GB | Operating Instruction
Before/after 10 hours
each use
X
X
(Fig. 25)
X
25 hours 50 hours /
half year
X
X
whenever necessary
X
whenever necessary
X
whenever necessary

4.2 Change the blade

WARNING! Wear safety gloves when working
on the blade and close to it! Use proper tools
to remove debris, e. g. a wooden stick! Never
use your bare hands!
Always use original spare parts for replace-
ment. The replacement of the blade should
be done by a qualified specialist! Rework or
sharpening blades is not recommended un-
less it is done by a repair service or a simi-
larly qualified specialist!
NOTE: We strongly recommend jacking the
product up when performing inspection and
work on the cutting device. Avoid tilting the
product in order to prevent fuel and oil leak-
ages.
1. Keep the underbody and blade clean and free of de-
bris. Remove clippings from the discharge chute.
2. Check all nuts and bolts periodically for tightness
before operation. After prolonged use, especially in
sandy soil conditions, the blade will become worn and
lose some of the original shape. The cutting efficiency
will be reduced and the blade should be replaced.
3. Keep the blade sharp to ensure a good cutting per-
formance. Replace a worn or damaged blade with a
new one of the same type or have it sharpened by a
qualified specialist.
13
100 hours /
once a year