Husqvarna HU625HWT Operator's Manual page 6

The operation ofany trimmer can result inforeign objects being t hrown
into the eyes, which c an result insevere eye damage.
Always wear s afety g lasses oreye shields while operating your trimmer
orperforming any adjustments orrepairs. We recommend standard
safety glasses orawide vision s afety m ask w orn over spectacles.
HOW TO USE YOUR TRIMMER
ENGINE SPEED
The engine speed is controlled by a throt-
tle located on the side of the upper handle.
FAST position is for starting and normal
trimming. SLOW is for light trimming and
fuel economy. STOP is for stopping the
engine. @
/rt _t
_ ( J/
TO ADJUST TRIMMING HEIGHT
ACAUTION: Stop the engine and wait for
all moving parts to stop. Disconnect spark
plug wire from spark plug and place wire
where it cannot come in contact with plug.
The hetght of cut can be set to six (6) dif-
ferent positrons ranging from I-1/2 inches
to 3 inches. Recommended cutting height
for the average yard is 2 inches.
1. To adjust trimming height, push in the
locking plate tab and move trimmer
head up or down to desired position.
2. Release tab and be sure head ts
locked into one of the six (6) height
positions.
TRIMMER HEAD DRIVE CONTROL
Your trimmer is equipped with a trimmer
head drive control bar whtch will require
the operator to be positioned behind the
trimmer handle to operate the trimmer.
• To start trimmer head rotation, push the
trimmer head control lever (1) forward
and hold the trimmer head control bar
down to the handle (2).
• To stop trimmer head rotation, release
the trimmer head control bar.
\ _ Trimmer head
\ \ lever
\
'_ Trimmerhead
control bar
\\
\
\
\\
\
\
TO ENGAGE
TRIMMER HEAD
Trimmer
Head
Locking X
Plate Tab
BEFORE STARTING ENGINE
ADD OIL
Your trimmer is shipped w_thout oil in the
engine. For type and grade of oil to use,
see "ENGINE" in the Maintenance section
of this manual.
A CAUTION: DO NOT overfill engine with
eli, or it will smoke on startup.
1. Be sure trimmer is level and area
around oil fill is clean.
2. Remove oil dipstick from oil fill spout.
Make sure that rim of spout is clean.
3. You receive a container of oil with the
unit. Slowly pour the entire container
down the oil fill spout into the engine.
NOTE: Initial oil fill requires only 18 oz.
due to residual oil in engine from the
manufacturers 100% quality testing. When
changing oil you may need 20 oz.