Engine Speed - Husqvarna HU625HWT Operator's Manual

1I.Assemble new belt, idler p ulleys and
bottom belt k eeper toidler b racket,
Tighten pulley bolts s ecurely.
NOTE: Besure belt i sinside t op belt
keeper onidler a ssembly.
12. Position belt a nd idler a ssembly in
trimmer, reconnect idler s pring a nd as-
semble idEer tochassis.
Engine pulley
Chassis
.../""..
/
(
L.
Controlcable
Belt
Idlerassembly
Top belt keeper Bolt/
ENGINE SPEED
Your engine speed has been factory set.
CARBURETOR
Your carburetor has a nonadjustable fixed
main jet for mixture control.
IMPORTANT: Never tamper with the
engine governor, which is factory set for
13. Install belt around trimmer head pulley
and engine pulley.
NOTE: Be sure belt is inside beft keeper,
14. Replace debris shield and tighten the
four (4) screws securely.
15. Replace chassis cover and tighten
screw securely.
Nut
Idler bracket
Spacer
Flat idler
Bottom
"_. belt
keeper
Flatidler
Trimmer head pulley
proper engine speed. Overspeeding
the engine above the factory high speed
setting can be dangerous. If you think
the engine-governed high speed needs
adjusting, take your unit to a qualified
service center, which has proper
equipment and experience to make any
necessary adjustments.
Immediately prepare your trimmer for stor-
age at the end of the season or if the umt
will not be used for 30 days or more.
TRIMMER
When trimmer is to be stored for a period
of time, clean it thoroughly, remove all dirt,
grease, leaves, etc. Store in a clean, dry
area.
t. Clean entire trimmer (See "CLEAN-
ING" in the Maintenance section of this
manual).
2, Lubricate as shown in the Maintenance
section of this manual.
3. Be sure that all nuts, bolts, screws, and
pins are securely fastened. Inspect
moving parts for damage, breakage
and wear. Replace if necessary.
12