Service Manual
Diagrams and Replacement
Parts List
Blu-ray Disc Recorder
Model No.
DMR-BS750EG
DMR-BS850EG
Vol. 1
Colour
(K)...........Black Type
Table of contents
S2.2. AV_IO P.C.B. ......................................................................... S-3
S2.3. CI P.C.B. ................................................................................ S-4
S2.4. Front_R P.C.B. ...................................................................... S-5
S3. Block Diagram .......................................................................... S-6
DSD1003015CE
S1. About Indication of The Schematic Diagram
S1.1. Important Safety Notice
COMPONENTS IDENTIFIED WITH THE MARK
FOR SAFETY. WHEN REPLACING ANY OF THESE COMPONENTS USE ONLY THE SAME TYPE.
1.Although reference number of the parts is indicated on the P.C.B. drawing and/or
schematic diagrams, it is NOT mounted on the P.C.B. when it is displayed with "$" mark.
2.It is only the "Test Round" and no terminal (Pin) is available on the P.C.B.
when the TP (Test Point) indicated as "
3.The voltage being indicated on the schematic diagram is measured in
"Standard-Playback" mode when there is no specify mode is mentioned.
4.Although the voltage and waveform available on here is measured with standard frame,
it may be differ from actual measurement due to modification of circuit and so on.
5.The voltage being indicated here may be include observational-error (deviation) due to
internal-resistance and/or reactance of equipment. Therefore, handle the value
indicated on here as reference.
6.Use the parts number indicated on the Replacement Parts List .
7.Indication on Schematic diagrams:
S4.9. Front_R Schematic Diagram ............................................... S-36
S5.2. AV_ IO P.C.B. ...................................................................... S-46
S5.3. CI P.C.B. .............................................................................. S-48
S5.4. Front_L P.C.B. ..................................................................... S-52
S5.5. Front_R P.C.B. .................................................................... S-52
S-1
" mark.
Circuit name being connected.
This signal is connected
OFTR
FEP
to the FEP schematic diagram.
Name of Signal
S6. Abbreviation ........................................................................... S-55
S8. Exploded View ....................................................................... S-72
HAVE THE SPECIAL CHARACTERISTICS