Silver Marine Calypso 330 WD Owner's Manual
  1. Manuals
  2. Brands
  3. Silver Marine Manuals
  4. Boat
  5. Calypso 330 WD
  6. Owner's manual

Silver Marine Calypso 330 WD Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Calypso 300 WD
Calypso 330 WD
Owner's manual
www.silvermarine.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Calypso 330 WD and is the answer not in the manual?

Questions and answers

Related Manuals for Silver Marine Calypso 330 WD

Summary of Contents for Silver Marine Calypso 330 WD

  • Page 1 Calypso 300 WD Calypso 330 WD Owner’s manual www.silvermarine.com...

  • Page 2: Table Of Contents

    STEP THREE: FLOORBOARD SEAT AND BENCH BAG ASSEMBLY........7 STEP FOUR: OAR FITTING AND ASSEMBLY...............8 STEP FIVE: SELF-BAILING DRAIN VALVE................8 MOTOR INSTALLATION......................9 DEFLATION AND DISASSEMBLY.....................9 PRESERVATION........................9 MAINTENANCE........................10 REPAIRING..........................10 FOLDING & STORAGE......................11 OPERATION ON YOUR SILVER MARINE®................12 Rowing..........................12 Motoring & Safety.......................12 Towing..........................12 Stability and buoyancy.......................12 TROUBLESHOOTING CHART....................13...

  • Page 3: General Introduction

    This manual has been compiled to help you achieve long term safe use, and pleasure from your Silver Marine®. Please read it carefully and familiarize yourself with the craft before boating. Designed for voyages in coastal waters, large bays, estuaries, lakes and rivers where conditions up to,...

  • Page 4: Structure Terminology

    8. Beam 9. Transom 10. Length overall 11. Starboard side 12. Port side TECHNICAL SPECIFICATIONS MODEL Calypso 300 WD Calypso 330 WD DESIGN CATEGORY C, TYPE V C, TYPE V STANDARD NO. EN ISO6185-2:2001 EN ISO6185-2:2001 DIMENSIONS 2.94 x 1.53m 2.94 x 1.53m...

  • Page 5: Parts Terminology

    PARTS TERMINOLOGY...

  • Page 6: Packing List

    PACKING LIST Calypso 300 WD & Calypso 330 WD: Boat Hull, Oars, Foot Pump, Pressure Gauge, Wooden Seat, Docking Rope, Safety Grab Line, 4 Screw Valves + 1 Drain Valve, Repair Kit, Carry Bag, Boat Cover and Bench Bag. 4 pieces Floorboards; 3 pieces Stringer (66cm); 2 pieces Stringer (90cm).

  • Page 7: Step Two: Inflation

    Calypso 300 WD&330 WD are equipped with an interlocking floorboard system which has 4 pieces wooden floorboard. Calypso 300 WD & Calypso 330 WD 1. Install Bow Floorboard Start by fitting the wooden bow board, between air tubes and bottom. Slide and push it forward as far as possible, until it has reached the top of the bow, and the air valve of the inflatable keel fits into the hole of the bow board.

  • Page 8: Step Three: Floorboard Seat And Bench Bag Assembly

    5. Seat Installation When the wood deck is in position, hook the plastic brackets at the bottom of the seat onto the PVC straps on your Silver Marine® boat. 6. Seat bag assembly After the Seat Assembly, attach the bench seat bag onto the bench seat.

  • Page 9: Step Four: Oar Fitting And Assembly

    STEP THREE: FINISH INFLATION After inflating the tubes, insert the barometer against the valve. Check if the pressure in the air chambers reaches 0.25 bars, then remove the barometer and screw the cap on. STEP FOUR: OARS FITTING AND ASSEMBLY 1.

  • Page 10: Motor Installation

    PRESERVATION You should endeavour to keep your Silver Marine® in good condition. Preferably store it deflated. If you leave it outside, raise it off the ground and cover it from the elements especially strong sunshine, or heavy, cold, raining, conditions.

  • Page 11: Maintenance

    5. Check the inflation valves, clean them and remove any sand or debris. REPAIRING Your Silver Marine® boat comes with a repair kit for patching minor punctures. Most leaks only take a few minutes to repair. Air Leakage: If your boat appears a bit soft, it might not be because of a leak, since any change in temperature can cause modifications 0.003 bar (0.045 psi) per Celsius degree (34F).

  • Page 12: Folding & Storage

    7. Fold the bow section on top of the previously folded rear part of the boat. Place the boat inside your Silver Marine® carry bag or protective coving. When storing your inflatable boat, ensure protection against rodents and other vermin, as they feed on the fabric of the boat.

  • Page 13: Operation On Your Silver Marine

    OPERATION ON YOUR SILVER MARINE® Rowing Silver Marine® transom boats are great tenders and can be rowed easily. The oars are attached to the swiveling oarlocks, which allow for easy rowing. Snap the rear blade section of the oar out of the clasp and the oarlock will pivot out for instant use.

  • Page 14: Troubleshooting Chart

    TROUBLESHOOTING CHART PROBLEM POSSIBLE REASONS POSSIBLE SOLUTION(S) Rise or drop in temperature MAINTENANCE (P8) Plastic valve cap has not been fitted MAINTENANCE (P8) Buoyancy chamber looses air Loose valve MAINTENANCE (P8) Puncture REPAIRING (P9) Inflatable keel is not sufficiently inflated STEP ONE: STARTING UP (P4) Buoyancy collar is not sufficiently inflated Floorboards not rigid...
  • Page 16 Designed in USA by Silver Marine International Co., Ltd ©2008. All rights reserved. www. silvermarine.com...

This manual is also suitable for:

Calypso 300 wd

Table of Contents