Advertisement
MAXP4Z60N 4 CHANNEL AMPLIFIER APPLICATIONS
4 CHANNEL FULL RANGE SYSTEM
Here we show how to use the 4 channel amplifiers as
straightforward discrete 4 channel full range units.
Interconnect cable checklist:
- Connect the four inputs of the amplifier to a Radio/CD
with quality RCA cables.
Switch seHing checklist.:
"IjZCH X'()VER:
FULL
-3/4CH X'()VER:
FULL
Crossover frequency contra. checklist:
Channels IjZ:
Channels 3/4:
-HIGH PASS: NfA
-HIGH PASS: NfA
-LOW PASS: NfA
-LOW PASS: NfA
Level control checklist:
- Refer
to
the section "setting up systems after installation for
best performance"
Minimum final loudspeaker Impedances:
- 2 ohm per channel.
Z
or 3 CHANNEL FULL RANGE SYSTEM
FUll RANGE
STEREOUNE
INPUTS
Here we show how to use the 4 channel amplifiers as full range
2 or 3 channel units by taking advantage of the mono bridging
capability of alllanzar MAX PRO series amplifiers.
TIP:
If you
are using the mono sub bass output of an active crossover, there is nothing wrong
with switching in the low pass filter in these amplifters for a steeper low pass rolloff.
The follwing example shows how to create a 3 channel system
by
mono bridging channel pair
3 / 4.
In order to create a
2
channel
system. simply follow the example to also mono bridge channel pair 1/2.
Interconnect cable checklist:
- Connect the inputs of channel pair 1/2 to a suitable stereo source.
e.g. a head unit with good quality RCA cables.
- A MONO signal source is required to bridge channel pair3/4. such
as would be available from the mono sub bass output of an active
crossover, whether standalone. or built into a head unit or equalizer.
1 STEREO
Level control checklist:
- Refer to the sectlon "Setting up systems after installation for best performance"
Minmum final loudspeaker impedances:
"Z ohm per channel In stereo mode.
"4 ohm mono bridged.
Important:
Do not be tempted to connect the hot or positive
I MONO
outputs, from any source together to obtain a mono Signal, as this
~~~-;:~:=
could very well damage the outout stage of that source.
-It is necessary
to
feed the SAME signal to both left and right inputs
via a Y-adapter RCA cable.
- Connect the mono speaker positive terminal to the RIGHT +. and
its negative terminal to
lEFT -
as shown.
5wJtch seHlng checklist:
-lfZCH X'()VER:
FULL
-3/4CH X'()VER:
FULL
Crossover frequency control checklist.:
channels 1/Z:
channels
3/4:
"HIGH PASS: NfA
- HIGH PASS: NfA
"LOW PASS: NfA
_ LOW PASS: NfA
OR HIGHS
SPEIIKERS
MONO
r--~JJo'SUB BASS
SPEAKERS
Hide quick links:
Advertisement
