Roper B9907X0 Use And Care Manual page 11

TO SET A.CLEAN CYCLE
The sell cIean\nq cyclws preproqrameo lr)r 3% hours You Can also set
the elecironlc range conlrol lor a
'deldved
start 01 rhe clean cycle
To self-clean
1 Slide the door lock handle to Ihe right You may need to press the
door slfghtly lo get II to lock properly
Never It-y lo force fhe door lock handle Forcing the handle may
damage the door IoCklng mechanism
2. Push CLEAN button The oven begins to heat wlthln 2 seconds
Note: You can llnd out when the clean cycle will be llnlshed by pushing
the STOP TIME butlon
To use delayed sell-clean:
1
Push STOP TIME button
2 Turn SET knob IO time 01 day when you wish cleaning to be completed
(must be more than 3% hours later than current tlme ol day)
3. Slide Ihe door lock handle lo fhe rIghI. You may need lo press Ihe
door sllghlly lo gel
II IO
lock properly. Never lty lo force the door
lock handle Forcing lhe handle may damage the door lockmg
mechamsm.
4
Push CLEAN bulron
Note. Dunng a delayed sell-clean operation you can tend out when the
oven turns on by pushtng and holding the CLEAN butIon
TO STOP A CLEAN CYCLE:
1
Press rhe OVEN CANCEL butlon
0
2 wat until the oven has cooled below the locking
lempWalUW (20-30
z
minutes) and the word LOCK
IS
OH In the Electronic Range control
&splay
4
3 Slide the door handle IeR 10 unlfxk Ihe door You WIII not be able lo
T
unlock the Oven
UhleSS
the oven temperature 1s at a safe level Never
tn
force lhe door IocWunlock handle
5
WHEN A CLEAN CYCLE IS FINISHED
a
1
Walt unlll the oven has cooled below lccklng temperature (20.30
0
minutes) and the word LOCK IS otl In fhe Etectronlc Range Control
display
e
2 Slide the door IocWhandle left to unlock the door You WIII nol be able
(0
to unlock the oven unless the oven temperature IS at a sale level Never
force the door lock handle
Note: II the door does not unlock because the temperature has not had
time IO drop IO a safe level when you llrst try to open the door. be sure
to slide the door lock/unlock handle back all the way to the right
AFTER A CLEAN CYCLE
After a clean cycle, you may nolIce some white ash In the oven Just wipe
II up with a damp clolh
If white spots remaln, remove them with a soap-Illled steel wool pad Be
sure to rinse thoroughly with a vinegar and water mlxture These deposits
are usually a salt residue thal can not be removed by the clean cycle
II the oven IS not clean atler one clean cycle, the cycle may be repeated
11