Connect The Handheld To Your Pc - Blackberry RIM 850 Installation And User Manual

2. When Setup is complete, you may choose to open the README
file and run the Desktop Software right away.

Connect the handheld to your PC

Note
When connecting the handheld to the PC, use only the
charging cradle provided by Research In Motion Limited.
When you first receive your handheld, you must insert it into
the cradle (with the AC connector plugged into a power
outlet) and allow the handheld to fully charge to activate it.
1. Ensure that you have properly installed the Desktop Software.
If it is not already open, launch the Desktop Manager by
selecting it from the Start>Programs menu.
2. Plug the charging cradle into an available power source (if you
are using a rechargeable battery, otherwise leave unplugged).
Insert the end of the charging cradle cable into a COM port on
the back of your PC.
3. Secure the handheld in the cradle by inserting the connector
port on the bottom edge of the handheld into the connector
prongs of the cradle and press firmly in place.
Note
If the password is enabled, you must enter it before you can
connect to the desktop. See page 40 for more information
on the password.
Start sending email — Connect the handheld to your PC
Installation and User's Guide
49