Troubleshooting Tips - POLTI unico MCV85 total clean & turbo Instruction Manual

27. TROUBLESHOOTING - TIPS
PROBLEM
UNICO does not turn on.
The motor revs/has little suction
UNICO has no/reduced suction
Water collects under the appliance during
vacuuming of liquids and/or damp dirt.
UNICO does not dispense steam.
The universal brush selector does not work.
In preset-program mode, at the end of suction,
there was no time to finish drying.
During cleaning operations, lines or traces of
dirt remain.
Non-uniform drying of the hard floor.
CAUSE
No power.
Tubes or accessories blocked
Dirt collector full or not correctly
inserted.
Suction adjustment set at the minimum
level.
Dirt collector or vacuum tube not
correctly inserted.
Clogged filters.
Clogged suction tubes.
Liquid in dirt collector has exceeded the
MAX level.
Foam in the dirt collector.
Boiler switched off.
Boiler out of water.
Steam hose not inserted.
Steam lock activated.
The boiler is not yet pressurised.
The holder with cloth for steam cleaning
is mounted on the brush.
Vacuuming too slowly over the surfaces.
The Multibrush is dirty.
The rubber inserts are worn.
| 40 |
SOLUTION
Check the cable, plug and socket.
Turn the appliance off, unplug, remove any
blockages in the tubes and accessories.
Empty the dirt collector and insert correctly.
Adjust suction using the cursor on the handle.
Correctly insert the dirt collector tank and/or check
that the flexible vacuum tube has been correctly
inserted.
Proceed with filter cleaning as described in chapter 18.
Clean the tubes, as described in Chapter 22.
Empty the dirt collector.
Follow the cleaning instructions in Chapters 17 - 18
- 22.
Turn on the boiler button.
Add water to the tank as described in Chapter 15.
Connect the steam hose to the flexible vacuum
tube, locking the automatic buttons; connect the
steam hose to the appliance and the handle (as
described in Chapter 1 and shown on page 2).
Deactivate the steam lock on the handle.
Wait for the steam indicator light to stop flashing.
Remove the holder with cloth from the brush.
In preset-program mode, it is still possible to
activate suction by pressing the suction button.
Clean the Multibrush by washing it under running
water and wait for it to dry completely before using
it again.
Replace the inserts, as described in Chapter 23.