AGFA Drystar 5300 Reference Manual page 21

Working with Compact flash cards (CF-card)
The Drystar 5300 is equipped with an external CF-card slot.
A CF-card has the following physical characteristics:
•
a flat surface on one side (there is also often a label present),
•
a small rim on the other side,
•
connector holes on the opposite side of the rim side.
Inserting a CF-card
To insert a CF-card in the Drystar 5300 (the slot is located at the rear side):
1
Hold the CF-card vertically with the connector holes in front of the slot, and
with the flat surface pointing to the left.
2
Insert the CF-card gently into the slot, and push it until the unlocking lever
underneath the slot comes out.
" If you cannot push the CF-card completely into its position, this means
that you have to turn it 180 degrees (while keeping the connector holes
faced to the slot).
2920B EN 20031206
21