Troubleshooting Guide; Replacement Parts - Ninja Coffee Bar CF110 Series Owner's Manual

Troubleshooting Guide

PROBLEMS
If there is sediment at the bottom of the brewed coffee, this may be due to finely ground coffee in a
permanent filter.
Sediment in my coffee.
To reduce the amount of sediment in the brewed coffee use a slightly coarser grind or use a paper
filter.
If there are grounds in your coffee, check to make sure the brew basket did not overflow.
If there are too many grounds in the brew basket, or you are using a fine ground coffee, the
Grounds in my coffee.
grounds will flow into an overflow channel designed to make sure overflow is captured in the brew
vessel. For best results use medium ground coffee in the recommended measurements.
Brew basket dripping
Run a Clean Cycle or wash the brew basket thoroughly with warm, soapy water.
after brew.
The Ninja Coffee Bar
for best results.
Paper filter falling
Be sure the paper filter is firmly pressed into the brew basket.
over.
Wet the corners of the filter for best results.
If problem persists, try using the permanent filter.
To keep your coffee hotter longer, preheat your mug by rinsing it with hot water from the tap.
Coffee is not hot
If using a microwave safe mug with cream or milk, try preheating the cream or milk in the microwave
enough.
for 30 seconds.
Over Ice Brew is not
The Over Ice Brew is designed to brew hot coffee over ice to lock in the flavor for rich, smooth iced
cold. coffee. Make sure your cup or travel mug is filled all the way to the top with ice cubes.
If the coffee tastes weak, try adding more coffee grounds into the brew basket for the next brew
cycle.
Weak coffee.
If the coffee is still weak after adding more coffee grounds, try Rich Brew to make a stronger, more
concentrated cup.
Try using a coarser grind.
Coffee too strong.
If the coffee is still too strong, try using less coffee grounds.
Check to make sure the brewer is plugged in and water is in the water reservoir.
Brew will not start.
NOTE: The brew will begin, stop, and be quiet for a short period of time before it begins again. This
process is used to evenly saturate your coffee grounds.
A single-cup brew will take approximately 4 minutes.
Brew cycle is too slow.
If the brew cycle is taking longer than normal, run the Clean Cycle with the descaling solution.
15 1-877-646-5288
POSSIBLE REASONS & SOLUTIONS
is designed to take a #2 cone filter. Be sure you are using this size and shape
®
PROBLEMS
The cup or travel mug may not have been empty prior to brewing.
The water exceeded the Max Fill line on the water reservoir prior to brewing.
The Ninja Coffee Bar
Cup
Tall Cup
My cup or travel mug
Travel Mug
overflowed.
XL Travel Mug
Please ensure that you are using at least a 12 oz. cup for the cup size, 14 oz. cup for the
tall cup size, 16 oz. travel mug for the travel mug size and 20 oz. travel mug for the XL
Travel Mug size.
NOTE: On Rich Brew and Over Ice Brew there will be less volume dispensed. Specialty
Brew will deliver approximately 4 oz. and Cafe Forte will deliver approximately 8 oz.
Brew basket overflowed.
Check the amount of coffee or type of grind used.
If water was filled above the Max Fill line, water may overflow from the overflow hole at
My water reservoir is
the top of the hand grip. Remove the water reservoir from the brewer and empty to the
leaking.
Max Fill line.
Ninja Coffee Bar ®
and Auto-iQ ™ One Touch Intelligence will only use the water needed for the brew size
and style selected.
Water left in my
After a brew you may notice leftover water in your water reservoir after filling to the
reservoir. minimum fill line of the size selected. The water reservoir markings are minimum fill lines
that indicate if there is enough water for the proper brew size in the reservoir, but all
brew styles use different amounts of water to create the proper flavor and concentration.
You can brew multiple cups before needing to refill.
Does it take coffee pods?
This brewer is designed to brew coffee grounds only. Do not insert pods or K-Cups
If the leak is coming from the brew basket, be sure all the parts are fit securely in the brewer.
My Ninja Coffee Bar is
®
leaking.
If the leak is coming from the bottom of the brewer call customer service at 1-877-646-5288.
Ensure the water reservoir is locked in place and is filled with enough water for the
My Ninja Coffee Bar ®
desired brew.
beeped and did not
Check the CLEAN indicator light. If illuminated, run a Clean Cycle with the appropriate
complete the full brew
descaling solution or a white vinegar mixture. See Care & Maintenance section.
that I selected.
If the problem persists please call customer service at 1-877-646-5288.
Why is the second cup
Once the Ninja Coffee Bar
that I brewed hotter
This enables any following brews to be slightly hotter. For a hot first cup try pre-warming
your mug.
than the first brew?
*K-Cup is a registered trademark of Keurig Green Mountain, Inc. Use of the K-Cup trademark does not imply any affiliation with
or endorsement by Keurig Green Mountain, Inc.

Replacement Parts

ORDERING REPLACEMENT PARTS
To order additional parts and attachments, please visit ninjacoffeebar.com
or feel free to contact customer service: 1-877-646-5288.
POSSIBLE REASONS & SOLUTIONS
is designed to dispense the following amounts on classic brew:
®
9.5 oz
11.5 oz
14 oz
18 oz.
allows you to fill the reservoir up to but not exceeding the Max Fill line
® has brewed the first cup, the brewing system is pre-warmed.
ninjacoffeebar.com
.
®
16