BEFORE YOUR
FIRST BREW
Before first use, plug in your brewer
and run two Multi-Serve Clean cycles.
With your water reservoir filled to the
max line with fresh water, your brewer
plugged in, and a 22 oz. or larger
container in place, press the CLEAN
button to start a cycle.
(Discard the brewed water after each cleaning cycle.)
For how-to videos and more, visit ninjacoffeebar.com | Questions? 1-877-646-5288
FROTHING
1. Add milk to your cup
2. Hold the cup under the
until it is about
⁄
full,
frother and submerge
1
3
then microwave for
the whisk just below the
45–60 seconds.
surface of the milk. Froth
for 30–45 seconds.
CAUTION: DO NOT reach across top of brewer to froth during brewing. Steam is released from vent on top of
brewer and can result in a steam burn.
DRIP STOP
CLEANUP
STOP THE DRIPS AFTER THE BREW
REMOVABLE BREW BASKET
At the end of a brew, close the drip
FOR EASY CLEANUP
stop to prevent drops of coffee
To avoid spills and drips, keep the
from escaping.
filter inside the removable brew
basket as you carry it to the trash.
For how-to videos and more, visit ninjacoffeebar.com | Questions? 1-877-646-5288
Please make sure to read the enclosed Ninja
1
FILLING THE WATER RESERVOIR
3. Remove the frother whisk
by twisting clockwise. Keep
your cup below the whisk while
you carry it to your sink or
dishwasher for easy cleaning.
FILL TO THE MAX LINE.
Let Auto-iQ
™
take it from there.
2
PLUG IN, POWER UP, AND PRE-HEAT
Our pre-heat function ensures your first cup will be as hot as it possibly can be.
If you don't have time to wait, you can still brew before pre-heat is fully activated.
Press the Power button
to turn the brewer on.
For how-to videos and more, visit ninjacoffeebar.com | Questions? 1-877-646-5288
CF112
Owner's Guide prior to using your unit.
®
QUICK START
GUIDE
The water reservoir lid is removable for
easy cleaning and is dishwasher safe.
The PRE-HEATING notification
light will illuminate for 3
minutes as it warms up.
When the light turns off,
it's time to brew.