Advertisement
Details of your installer:
Name of installer:
Address:
Contact:
Phone number:
Phone number outside business hours:
Ditributor for UK
ATAG Heating UK Ltd. • Unit 3 • Beaver Trade Park • Quarry Lane Chichester
West Sussex PO19 8NY • Phone: 01243 815 770 • Fax 01243 839 596
E-mail: info@atagheating.co.uk • Internet: www.atagheating.co.uk
Ditributor for Ireland
Total Energy Management Ltd. • Unit 9 • Ballybritt Industrial Estate • Monivea
Road Galway Ireland • Phone: 091 769174 • Fax 091 769485
E-mail:
info@tem.ie
•
Internet:
www.tem.ie
O p e r a t i n g In s t r u c t i o n s
Q-Solar
Advertisement
Table of Contents
Related Manuals for Atag Q-Solar
Summary of Contents for Atag Q-Solar
- Page 1 Phone number outside business hours: Ditributor for UK ATAG Heating UK Ltd. • Unit 3 • Beaver Trade Park • Quarry Lane Chichester West Sussex PO19 8NY • Phone: 01243 815 770 • Fax 01243 839 596 E-mail: info@atagheating.co.uk • Internet: www.atagheating.co.uk Ditributor for Ireland Total Energy Management Ltd.
-
Page 2: Table Of Contents
Adjustments............ 14 Important! It is in your own interest that we should know that you have an ATAG boiler. Please fill out the warranty card completely and send it back to us. Then we can be fully at your service. -
Page 3: Introduction
Introduction These operating instructions describes the functioning and the operating of the ATAG Q-Solar boilers. This manual is for the end user. For installation and servicing there is a installation & servicing instructions manual for the installer. Read this manual fully before operating the boiler. In case of doubt or errors contact your installer. -
Page 4: Safety
The display will show StbY for a short while and installation regularly. Use only potable water for filling. will return to the Technical reading. Additives only after clearance by ATAG. Flow water Contact your installer in case of doubt. Selection... -
Page 5: Description Of The Boiler
Adjustments Description of the boiler The boiler has a large number of settings options. The ATAG Q-Solar boiler is a room sealed, We advise you to contact your installer for condensing and modulating central heating boiler adjusting the boiler to the required settings. - Page 6 SEDBUK Class A. You can find the warranty conditions in the warranty card which is supplied with the boiler. When the boiler is connected to an ATAG BrainQ information interchange takes place between the boiler and the BrainQ. For more information...
- Page 7 Turning the boiler off Hydraulic layout Q-Solar Holiday period: Holiday The ATAG BrainQ room Adjust the thermostat to the holiday period. See thermostaat is provided the BrainQ user manual. The hot water facility can with a holiday programm. be switched off by means of the program key The holiday period can be the control panel.
-
Page 8: Explanation Of The Function Keys And Display
The boiler will not function directly. The automatic de-aeration programm of Explanation of the function keys and display about 17 minutes will start after one of the three programm keys is pressed. The display will show where A stand's for Automatic de-aeration programm Active and the number on the right indicates the actual water On the left side of the boiler there is a small door. -
Page 9: The Reset Key
Replenishing the central heating system Frost protection The Q-Solar is provided with a frost protection for The central heating installation needs to be filled with potable (drinking) water. boiler and cylinder as standard. For topping up the installation you use the filling loop according to the following... -
Page 10: The Boiler Display
The technical reading To retreive the water pressure on the display from Message ' Water pressure During this reading the display will show in which too low' on your ATAG the Good reading: operating status the boiler is active. The technical thermostat.
Need help?
Do you have a question about the Q-Solar and is the answer not in the manual?
Questions and answers