General And Safety Information - Libelium Waspmote Quick Start Manual

2. General and safety information

Software:
• Upload code only using Waspmote IDE. If a different IDE is used, Waspmote can be damaged and can become
unresponsive. This use is not covered under warranty.
• Do not unplug any connector while uploading code. Waspmote can become unresponsive. This use is not covered under
warranty.
• Do not connect or disconnect any connector while Waspmote is ON. Waspmote can become unstable or unresponsive,
and internal parts can be damaged. This fact is not covered under warranty.
Hardware:
• Do not handle black stickers seals on both sides of the enclosure (Warranty stickers). Their integrity is the proof that
Waspmote Plug & Sense! has not been opened. If they have been handled, damaged or broken, the warranty is void.
• Do not open Waspmote Plug & Sense! in any case. This will automatically make the warranty void.
• Do not handle the four metallic screws of Waspmote Plug & Sense!. They ensures waterproof seal.
• Do not submerge Waspmote Plug & Sense! in liquids.
• Do not place nodes on places or equipment where it could be exposed to shocks and/or big vibrations.
• Do not expose Waspmote Plug & Sense! to temperatures below -10ºC or above 50ºC.
• Do not power Waspmote with other power sources than the original provided by Libelium. Voltage and current maximum
ratings can be exceeded, stopping Waspmote working and voiding warranty.
• Do not try to extract, screw, break or move Waspmote Plug & Sense! connectors far from necessary usage, waterproof
sealing can be damaged and warranty will be voided. For more information: http://www.libelium.com
• Do not connect any sensor on the solar panel connector and also do not connect the solar panel to any of sensor
connectors. Waspmote can be damaged and warranty void.
• Do not connect any sensor not provided by Libelium.
• Do not place Waspmote Plug & Sense! where water can reach internal parts of sensors.
Waspmote Plug & Sense! - Quickstart Guide
-4- v4.5