To Adjust Presser Foot Lifter Switch Position - Singer s18 Service Manual

TO ADJUST PRESSER BAR LIFTER SWITCH POSITION
Step3 Switch
SP FL
OFF UP
Display (A)
Setscrew (B)
Presser bar lifterswitch
Presser bar lifter
CL DD
OFF UP
Setscrew (B)
Switch set plate (C)
Switch set plate (C)
1. While pressing the needle up/down and lock
stitch buttons, turn the power switch on. Press
the number "9" in 3 seconds.
2. Remove the face plate and top cover plate (refer
to page 1).
3. When the presser bar is lifted or lowered, the
display (A) shows "UP" or "DOWN" respectively.
If not, loosen the setscrew (B) and adjust the
position of the switch set plate (C).
* When the presser foot is 3mm above the
surface of the needle plate, the display should
change "UP" or "DOWN".
4. Turn off the power switch.
5. Attach the top cover plate and face plate.
36