Drainage - Prem-I-Air PKY12 Manual

NOTE
1. To prolong the compressor's life, after switching off the unit, please wait forat
least 3 minutes before switch back on.
The cooling system will switch off if the ambient temperature is lower than
2.
thetermperature set. The ventilation, however, keeps working on the set level. If
the ambient temperature rises above the selected level, the cooling system will
start operating.

DRAINAGE

This unit is self-evaporating and the condensate will vent out of the exhaust hose.
However, during the coiling process any excess will collect in the reservoir inside the
unit.
If the reservoir is full
WATERFULL indication will illuminate. Pressing any button on the control panel will
stop this sound.
To enable the cooling system to start operating again, the water inside the unit
required draining in one of the following ways:
1. Turn off the air conditioner and unplug from the power socket. While the reservoir
is full, avoid moving the unit.
2. Place the Drain Pan underneath the Drain Cap in a tilted position.
3. Remove the Drain Cap (Turn anticlockwise).
4. Remove the rubber plug from the drain hole and allow the water to drain out.
5. Once drained replace the rubber plug and firmly tighten the drain cap.
6. Switch on the unit - the WATERFULL light should not be flashing.
If you wish to operate the unit without the need to empty, you can fit the optional drain
hose (not included).
1. Remove the drain cap and rubber plug, and
retain for future use. Connect the approx
20mm outer diameter.
2. The drain tube may be extended by adding
an extension tube and using a suitable
connector, (not supplied by the manufacturer)
Approx 18mm outer diameter.
Please note
•
The drain must be at or below the outlet level.
the compressor and motor will stop operating and the