Kenmore 110.20022012 Use And Care Manual page 6

O
CYCLE STATUS LIGHTS INDICATOR
Cycle Lid
Sensing Wash Rinse Spin Complete Locked
® • ® • ® Q
The Cycle Status Lights show the progress of a cycle. At each
stage of the process, you may notice sounds or pauses that
are different from traditional washers.
SENSING
Cycle Lid
Sensing Wash Rinse Spin Compmete Locked
0 • ® • • ®
When the START/PAUSE/Unlock Lid button is pressed,
the washer will flu to the selected water level. If the lid is
closed when the machine is done filling the lid will lock
and the machine wiU begin operation.
If the lid is open when the water stops entering the
machine, the cycle will not begin until the lid has been
closed and the START/PAUSE/Unlock Lid button is pressed.
If the cycle has not been started within 10 minutes of the
water filling the washer, the washer will pump out the
water.
NOTE: Avoid opening lid during sensing phase. The sensing
process will start over when the washer is restarted. The
sensing light may also come on during the Soak and Wash
portions of the cycle. This is normal. To restart the washer
after the lid has been opened press start.
WASH
Cycle Lid
Sensing Wash Rinse Spin Complete Locked
• 0 ® ® ® •
You will hear the agitator moving the load. The motor
sounds may change at different stages in the cycle. The
wash time is determined by the selected soil level.
SPIN
Cycle Lid
Sensing Wash Rinse Spin Complete Locked
® • 0 0 • ®
The washer spins the load at increasing speeds for
proper water removal, based on the selected cycle
and spin speed.
CYCLE COMPLETE
Cycle Lid
Sensing Wash Rinse Spin Complete Locked
® ® ® ® 0 ®
Once the cycle is complete, this light will come on. Remove
the load promptly for best results.
LiD LOCKED
Cycle Lid
Sensing Wash Rinse Spin Complete Locked
® ® • ® • 0
To allow for higher spin speeds, the lid will lock and the
Lid Locked light will turn on. When this light is lit, the lid is
locked and cannot be opened. When this light is blinking,
the washer is paused. When this light is off, the lid can be
opened.
If you need to open the lid, press START/
PAUSE/Unlock Lid. The lid will unlock
once the washer movement has stopped.
This may take several minutes if the load
was spinning at high speed. Press START/
PAUSE/Unlock Lid again to resume
the cycle.
I t_c. START
Unlock Lid
RINSE
Cyde Lid
Sensing Wash Rinse Spin CompleteLocked
® ® 0 Q ® •
You will hear sounds similar to the wash cycle as the
washer rinses and moves the load. You may hear the motor
turning on briefly (short hum) to move the basket while
filling. Fabric softener will be added if the "with Fabric
Softener" option was selected.
Some cycles use spray rinsing. After draining and spinning
out wash water, the washer will continue to spin and spray
in rinse water for the entire rinse time.
6