Table of Contents
Advertisement
English
m
For the Republic
of Ireland only
The information given in respect of Great Britain will frequently
apply, but a third type of plug and socket is also used, the 2-
pin, side earth type. In this case, the wire which is coloured
GREEN AND YELLOW must be connected
to the EARTH
contact, and the other two wires to the pins, irrespective
of
colour. The supply to the socket must be fitted with a 16 Amp fuse.
ADJUSTING THE TEMPERATURES (pi. A)
-Ton
<wARMEu
WLOER>
<WARMER
COLOER>
For the correct operation we suggest you adjust the tempera-
ture control knobs as indicated in figure. The left control knob
adjusts the temperature
in the refrigerator compartment;
the
right control
knob adjusts the temperature
in the freezer
compartment.
To obtain coldertemperatures
in the refrigerator
compartment,
turn the relevant control knob to the higher
numbers and the freezer control knob to position D; to obtain
warmer temperatures
turn the refrigerator control knob to the
lower numbers and the freezer control knob to position A.
To obtain colder temperatures
in the freezer compartment,
turn the freezer control knob to position A and the refrigerator
control knob to position 4.
Wait at least 24 hours between adjustments.
ANTI-CONDENSATION
DEVICE (Fig. B)
EXTERIOR
MOISTURE
CONTROL
OFF
ON
In normal ambient conditions,
set the switch to position OFF.
In particularly
high humidity ambient conditions,
we
suggest
you set the switch to the ON position. In this condition,
the
energy consumption
is slightly higher.
USE OF THE REFRIGERATOR
COMPARTMENT
(Fig. 8)
We recommend that you wrap all items stored in the refrigerator
compartment
in cling films, aluminium foil or keep them in a
covered
container.
This prevents
foods from losing their
freshness and stop strong smells and flavours being transferred
from one food to another. Some fruits with particularly
thick
rind or skin, can be stored without wrapping.
Different foods are best stored in the pcsitiis
indicated hereafter
Meat, fish: store in the appropriate
drawer.
Eggs,
cheese,
dairy
produces:
use the appropriate
compartments
in the inner door liner.
Butter: store in the compartment
in the inner door liner.
Fruits and vegetables:
store in the crisper drawers.
Beverages:
store on the inner door liner racks.
Canned
foods:
once the can has been opened,
transfer
unused food into a non-metallic
container.
Important:
Store all foods so as to permit free circulation
of
air.
Allow cooked food to cool before storing in the refrigerator
compartment.
Store liquids in covered containers.
ADJUSTING THE REFRIGERATOR SHELVES
Shelves can be adjusted to match the way you use your ref@xator.
Glass shelves are strong enough to hold bottles, milk and
other heavy food items.
However we suggest you remove them carefully.
To remove the shelves
(Fig. 7)
1. Lift up at front.
2. Lift up at back.
3. Pull shelf straight out.
To replace
the glass shelves
1. Guide the rear hooks into the slots in the shelf supports.
2. Tilt up front of shelf until hooks drop into slot. Lower front
of shelf to level position.
Removing the crkpers and crisper cover (Fig. 8)
To remove the crispers:
1. Slide crisper straight out to the stop, lift front, then slide the
rest of the way out.
2. Replace in reverse order.
To remove the cover (Fig. 9):
l.Pushupglassinsertfrombottom,thenslideoutwithbothhands.
2. Lift front of cover frame and pull it up and out.
3. Remove metal cover support.
4. Replace in reverse order.
Adjusting
the crisper
humidity
control
(Fig. 10)
Youcan~ltheamountofhumidityinthemoistu~crisper.
1. The control can be adjusted to any setting between LOW
and HIGH.
2. LOW (open) lets moist air out of crisper for best storage of
fruits and vegetables
with skins.
3. HIGH (closed) keeps moist air in the crisper for best storage
of fresh leafy vegetables.
Moving the meat drawer and cover
To remove the meat drawer
(Fig. 11):
1. Slide the meat drawer out to the stop.
2. Lift the front.
3. Slide the drawer the rest of the way out.
4. Replace in reverse order.
To remove the cover:
1. Tilt front of cover up, lift at back, and pull straight out.
2. Replace in reverse order.
9
Advertisement
Table of Contents
