Specifications; Power Amplifier Section; Preamp Section - Peavey 6505 212 Combo Owner's Manual

Power Amplifier Section:

Rated Power and Load:
60 W RMS into 16, 8 ohms
Power @ Clipping:
(Typically @ 5% THD, 1 kHz, 120 V AC line)
65 W RMS into 16, 8 ohms
Frequency Response:
+0, -3 dB, 50 Hz to 20 kHz, @ 50 W RMS into 8 ohms
Hum & Noise:
Greater than 74 dB below rated power
Power Amp EQ:
Active Presence: +10 dB @ 2 kHz
Active Resonance: + 10 dB @ cabinet resonant frequency
Power Consumption:
200 watts 50/60 Hz, 120 V AC (Domestic)

Preamp Section:

The following specs are measured @ 1 kHz with the controls preset as follows:
Low & High EQ @ 10
Mid EQ @ 0
Bright out
Lead & Rhythm Posts @ 10
Presence & Resonance @ 0 dB
Nominal levels with Pre Gains @ 5
Minimum levels with Pre Gains @ 10
Preamp High Gain Input:
Impedance: Very High-Z, 470K ohms
Lead Channel:
(with channel select in)
Nominal Input Level: -80 dBV, .1 mV RMS
Minimum Input Level: -92 dBV, .025 mV RMS
Clean Channel:
(with channel select out)
Nominal Input Level: -21 dBV, 85 mV RMS
Minimum Input Level: -32 dBV, 25 mV RMS
Maximum Input Level: 0 dBV, 1.0 V RMS
(Subtract 16 dB with Crunch switch in)
6505 212 Combo
™
Tube Guitar Amplifier

SPECIFICATIONS

12