Sony MHC-V77DW Operating Instructions Manual page 77

2
Touch FUNCTION repeatedly to
select "DVD/CD".
3
Remove the disc.
Touch  to open and close the disc
tray.
Wait until "NO DISC" appears on the
display.
4
Unplug the AC power cord (mains
lead).
Notes on discs
Before playing, wipe the disc with a
• •
cleaning cloth from the center outward
to the edge.
• • Do not clean discs with solvents, such
as benzine, thinner, or commercially
available cleaners or anti-static spray
intended for vinyl LPs.
• • Do not expose discs to direct sunlight
or heat sources such as hot air ducts,
nor leave them in a car parked in direct
sunlight.
On safety
Completely disconnect the AC power
• •
cord (mains lead) from the wall outlet
(mains) if it is not going to be used
for an extended period of time. When
unplugging the system, always grip the
plug. Never pull the cord itself.
• • Should any solid object or liquid get
into the system, unplug the system, and
have it checked by qualified personnel
before operating it again.
• • AC power cord (mains lead) must be
changed only at the qualified service
shop.
On handling the unit
Do not splash water on the unit
• •
on purpose. Dust and drip proof
performance is improved by the flat
top structure of the unit, but this is not
guaranteed for all the situations. If you
accidentally splash liquid on the unit,
wipe off immediately.
• • To maintain the dust and drip proof
performance, make sure all the covers
of the jacks/port/terminal are securely
closed.
On placement
Do not place the system in an inclined
• •
position or in locations that are
extremely hot, cold, dusty, dirty, or
humid or lacking adequate ventilation,
or subject to vibration, direct sunlight or
a bright light.
Be careful when placing the system
• •
on surfaces that have been specially
treated (for example, wax, oil, polish) as
staining or discoloration of the surface
may result.
If the system is brought directly from
• •
a cold to a warm location or is placed
in a very damp room, moisture may
condense on the lens inside the unit,
and cause the system to malfunction.
In this situation, remove the disc, and
leave the system turned on for about an
hour until the moisture evaporates.
On heat buildup
• • Heat buildup on the unit during
operation is normal and is not a cause
for alarm.
Do not touch the cabinet if it has been
• •
used continuously at a high volume
because the cabinet may have become
hot.
Do not obstruct the ventilation holes.
• •
On the speaker system
The built-in speaker system is not
magnetically shielded, and the picture on
nearby TV sets may become magnetically
distorted. In this situation, turn off the
TV, wait 15 to 30 minutes, and turn it back
on. If there is no improvement, move the
system far away from the TV.
IMPORTANT NOTICE
Caution: If you leave a still video
image or on-screen display image
displayed on your TV for an extended
period of time via this system, you
risk permanent damage to your TV
screen. Projection TVs are especially
susceptible to this.
77
GB