Shop-Vac H87 series User Manual page 7

NOTE: If cartridge filter has been used for wet pick
up, it must be cleaned and dried before using it for dry
pick up.
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
FIGURE 8
FIGURE 9
PAGE 6
11. With the tank cover in an
upside down position, slide
the cartridge filter down over
the lid cage, pushing until the
filter seals against the cover.
FIGURE 4.
12. Place filter retainer into the
top of the cartidge filter.
FIGURE 5.
13. Hold the tank cover with
one hand, turn the handle on
the filter retainer clockwise to
tighten, locking the filter into
place. FIGURE 6.
14. To remove the filter for
cleaning, again hold the
tank cover and turn the filter
retainer counter-clockwise to
loosen and remove.
FIGURE 7.
15. Slide the cartridge filter off
the lid cage. FIGURE 8.
16. To clean cartridge filter
shake or brush off excess dirt.
FIGURE 9.
FIGURE 10
18. Check the filter for tears or small holes. If none are
found, reinstall the filter. To prevent damage to your
vacuum, do not use a filter with a hole or a tear.
WARNING!
KEEP FILTERS CLEAN. EFFICIENCY OF THE VACUUM
IS LARGELY DEPENDENT ON THE FILTER. A CLOGGED
FILTER CAN CAUSE OVERHEATING AND POSSIBLY
DAMAGE THE CLEANER. CHECK THE FILTER
PERIODICALLY AND REPLACE AS REQUIRED.
INSTALLING THE DISPOSABLE FILTER BAG:
WARNING!
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
19. Use the disposable filter bag in conjunction with the
cartridge filter for easy disposal of the debris. The bag
is not required for normal dry pick up. When picking up
fine dust or powders a high efficiency filter bag (not
standard with all models) must be used. NOTE: Use
for dry pick up only.
20. With cord disconnected from the receptacle, pull
latches in an outward motion and remove the tank
cover.
FIGURE 11
FIGURE 12
17. Or rinse (from the inside of
the filter) with water.
FIGURE 10. Dry completely
(approximately 24 hours).
21. Unscrew hose locking-nut
and remove hose from inlet.
FIGURE 11.
22. Remove the inlet defector
from the deflector guide. NOTE:
Hose must be removed before
the inlet deflector can be taken
out. FIGURE 12.