Figure 2, Mov Wiring Diagram - Secura Key Radio Key 600 Operating & Installation Manual

Radio Key
®
RK600 Wire Connections
The RK600 Unit is supplied with a pre-wired connector (P1) with color-coded
wire leads. Referring to Table 2, Connector P1 Color Coding and Figure 3,
Wiring Diagram, make all appropriate connections from Connector P1 to
the power supply, locking device or gate controller, external alarm circuit
and Request-to-Exit (REX) input. Use solder and tape or gel-filled crimp-
on connectors.
Max relay power rating with resistive load is 2A@24V DC or AC;
Note:
0.5A@115VAC. Use an interposing relay to switch greater loads.
The RK600 does not supply power to operate electric strike or
magnetic locks - a separate supply is required. Refer to strike/
magnetic lock manufacturers instructions.
Users can request to exit through the controlled door without using a
transponder or PIN (and without causing an alarm condition), by pressing an
Exit button or triggering the relay output of an Exit PIR connected to the RK600
Unit. This will operate the latch relay for the programmed latch time.
When wiring the REX Input, connect the brown wire to one side of the REX
switch contact and connect the other side of the switch to the orange wire.
This input must be a dry contact, with no voltage present.
Use a Separate Power Supply for Electric Locks
The access control unit and the electric locking device should be connected
to separate power supplies. Install the MOV provided as shown below:
Auxiliary Reader Wire Connections
A short cable assembly extends from the back of the Optional Auxiliary
Reader. Connect Plug P2 at the end of the cable to Socket J2 at the RK600
Unit. If the cable must be extended, for the best performance, use TWO
SEPARATE CABLES: one unshielded, non-twisted, two-conductor wire to the
600
Figure 2 - MOV Wiring Diagram
Secura Key  10
Operating & Installation