Page 4
hardware 45mm x 4 12mm x 6 x 28 15mm x 24 15mm x 24 25mm x 8 x 36 x 36 31mm x 4 38mm x 4 Tools required flat-bladed cross-point hexagon key screwdriver screwdriver Measure (millimeters)
Page 5
hardware x 2 (L & R) 15mm x 4 (Packed with 13) x 2 (L & R) Tools required flat-bladed cross-point hexagon key screwdriver screwdriver Measure (millimeters)
Page 6
assembly A (L & R) C (L & R) B (L & R) x 12 Insert fittings 8 with arrowed slot pointing toward the hole in the nearest edge. Once assembled, use a x 12 large screwdriver to give 1/2 turn clockwise Repeat for remaining parts to lock.
Page 7
assembly Repeat for second assembled side...
Page 15
assembly Repeat for second door. Once the wardrobe is in position, use the screws on the hinges to adjust the fit of the doors.
Page 16
assembly To adjust the drawer alignment, rotate the small plastic tab on Part 13 under the drawer to raise or lower that side of the drawer. Repeat with the other side of the drawer if required.
Page 17
assembly The wardrobe is supplied with a fixing kit which will secure it and help to guard against accidental tipping. WARNING : Installation only to be carried out by a competent person. Check the suitability of the wall before fitting. Washer x 2 Screw (15mm) Screw (25mm)
safety ! Ensure that the wall strap is used to securely attach the wardrobe to the wall to prevent tipping. ! Only use the wardrobe on a stable and level surface. ! All assembly fixings should always be tightened properly. Care should be taken that no screws are loose because a child could trap parts of their body, or clothing (e.g.